Operation
CCMP encryption
On this page
The AES engine encrypts transmitted frames and decrypts received frames, both in place: only the payload between the CCMP header and the MIC changes, and a received frame reaches the host with its CCMP header and MIC still in it. One transfer at a time runs device-wide.
Sequence
classify the frame
|-- wait for BUSY clear before every command; later stages also wait for FIFO_READY
|-- if the key is not loaded: 4 FIFO words (16 key bytes), then 0x1100
|-- 16-byte CCM context block, then 0x1240
|-- AAD: 2-byte big-endian length and the first AAD bytes, then 0x1403 (TX) / 0x1402 (RX)
|-- remaining AAD words, then the tail command for the header shape
|-- SOURCE, DESTINATION, LENGTH
|-- write barrier
|-- start: 0x3008_1009 (TX) or 0x3008_1008 (RX)
|
|<-- IRQ 18 or IRQ 20
|-- read COMMAND_STATUS: for decryption, AUTH_OK is the MIC check
|-- start the next queued operation
Invariants
- One transfer at a time, device-wide.
- Key, AAD and payload stay in place until the transfer completes.
- The payload lies in DMA-visible packet RAM; the bus address is checked before the engine starts.
- A write barrier precedes the start command.
- Every FIFO and command wait is bounded, at 50 ms. A timeout is fatal until an engine reset sequence is known.